Answer to some product questions from customers

Q1: Why is it difficult for the CPU heat of a mobile phone to dissipate?

Because nowadays, phone cases are usually made of plastic and glass, both of which have poor thermal conductivity and heat dissipation capabilities

The constant difference causes the CPU to generate concentrated heat, which cannot be conducted to other areas and is difficult to dissipate into the air. guide

Causing continuous increase in CPU temperature and frequency lag.

So, the principle of our pure copper heat dissipation plate is to quickly transfer the heat from the high-temperature area of the CPU through heat transfer

Export the entire heat dissipation board to prevent high temperature accumulation in the CPU area. This not only increases the heat dissipation area,

Then, utilizing the strong heat dissipation ability of copper and graphene materials, the heat is quickly dissipated into the air.

Q2: Where should the heat distribution plate be attached?

The heat dissipation plate needs to be attached to the back cover of the phone in order to have good heat dissipation effect, and the phone case should be removed as much as possible, otherwise it will affect the heat dissipation of the heat dissipation plate.

Q3: Do I still need a radiator after buying a heat spreader?

In daily use, the heat dissipation plate can generally lower the temperature by about 3-5 degrees, but passive heat dissipation is still slow. If it is sent

For phones with very high heat, it is recommended to use a heat sink when playing games or watching videos for faster performance

Take away the heat from the heat distribution plate.

Q4: Why do we still need a heat spreader after buying a refrigeration radiator?

Due to the limited cooling area of the radiator, it can only be placed in the middle of the phone. However, the CPU of a mobile phone

Actually, they are all located in the upper area of the phone, which results in the effective area of the cooling radiator not being covered, and still cannot be provided

CPU effectively dissipates heat. So it is necessary to use a heat distribution plate to transfer the cold air to the CPU area for cooling.

Answer to some customer usage questions

Q1: Will it block NFC and wireless charging?

Any metal plate will block NFC and wireless charging, and all heat dissipation plates cannot solve this problem (usually

NFC is located next to the camera, and you can also choose the universal or universal extension without covering it.

Q2: Can the adhesive on the back of the heating plate be washed?

Cannot be washed, once washed, it will lose its stickiness (unless using a back clip radiator). We are professional thermal conductive adhesives,

It's not the ordinary non thermal conductive silicone that can be washed. The adhesive on the back of the heat equalizing plate must conduct heat, otherwise I wouldn't have bought the heat equalizing plate

The significance of the board is that even if it can be used for 100 years without thermal conductivity, it has not been used.

Q3: Will there be any glue left? Will it be too sticky and shatter the glass?

Normal materials for phone back covers, such as glass, frosted glass, plain leather, plastic, etc., do not leave any glue, and some may

The stickiness should be greater, so when tearing, it should be done slowly. But the aluminum alloy back cover is prone to leaving glue, it is recommended to stick a back cover

The film can be removed by spraying adhesive if there is no adhesive residue left.

The issue of sticking and shattering is often discussed in the comments section, where the glass back cover has already been broken or shattered

Sticky off, not caused by the uniform heating plate.

Q4: Magnetic suction force. Will the magnetic suction plate fall off when using a radiator?

Magnetic suction is a magnetic suction ring with moderate suction force, suitable for most circular magnetic radiators with a diameter of about 6CM(

Feizhi, Black Shark, and other compatible games. Magnetic suction comes with a circular magnetic suction sheet protective film, which can be peeled off from four magnetic suction pieces

Cover the small protective film with a circular protective film.